Add dynamic IPv6 addresses to Single IPS interfaces

You can add one dynamic IPv6 address to each physical or VLAN interface on a Single IPS engine.

1. In the navigation pane on the left, browse to Interfaces.
2. Right-click a Physical Interface or a VLAN Interface and select New > IPv6 Address.
3. Select Dynamic.
4. From the Dynamic Index drop-down list, select a DHCP index.
   The index is used for identification in other parts of the configuration (such as IPS Policies) to represent the possibly changing IP address.
5. If the interface is used for system communications and NAT is applied, add contact addresses.
   1. Enter the default contact address in one of the following ways:
      • In the Default field, enter the contact address.
      • Select Dynamic and define the translated IP address of this component.
   2. If components from some locations must use a different IP address for contact, click Exceptions and define the location-specific addresses.
6. (Optional) If you do not want a default route to be automatically created through the interface, deselect Automatic Default Route.
7. (Optional) If you want to use DHCPv6 to get the IPv6 address, select Use DHCPv6 to get IPv6 Address.
8. Click OK.
   The IP address is added to the interface.
9. Click Save.
   If you plan to add more IP addresses or change the roles that interfaces have in system communications, do not close the Engine Editor.

   Tip: Write down the networks to which each Interface ID is connected.