4. Finish setup when no policies were configured

Use this when you reached Step 3 by clicking Skip For Now on Step 2 and want to complete setup anyway. The page looks different in this state — you'll see a warning signal and an empty policies card.

Before you begin

How this state looks

Steps

  • The three-step progress indicator shows step 2 in yellow (⚠️ 2) instead of a green check, flagging that Data Protection was skipped.
  • The Policies Activated card is in an empty state with the message "No policies configured yet — Click button below to configure policies" and a Set Up A Policy button instead of the usual bulleted list.
  • The rest of the page — setup summary for connected apps, Finish button, What's Next cards — is unchanged.

Next steps

Steps

  1. Decide whether to add policies now or defer.

    • To add now (recommended): click Set Up A Policy in the Policies Activated card. You return to Step 2 and can use any approach from the Step 2: Data Protection guide.

    • To defer: leave the policies card empty and continue to step 2 below.

  2. Click Finish to complete setup. AI Security will start in Monitor-Only mode with connector visibility but no DLP detection active — you will see app usage and identity landscape but not sensitive-data events.

  3. When you're ready to add policies later, open AI Security → Policy from the left navigation, or use the Create Policies card in the What's Next section (see How-to 5).

Tip — Finishing with no policies is a valid strategy if you want to observe real traffic patterns before deciding which data types matter most. You'll get a week or two of usage data to inform your policy picks, then come back and enable them.