Installing the ZTNA connector using a ZTNA deployment script

The ZTNA Deployment Script allows you to install the ZTNA connector when deploying an OVA Virtual Appliance on a VM is not an option.

1. Login into the Forcepoint Data Security Cloud | SSE and navigating to Protect > ZTNA.
2. On ZTNA page, you can either download the ZTNA Deployment Script if the system you are planning to run this has access to a web browser or you download and move the script package over via scp/sftp.
   Alternatively, you can copy the Command Line (wget) command to have the package downloaded from the command line.
   
   
   1. To download the complete package in a tgz format, click the ZTNA Deployment Script.
   2. To download the package using the command line, click the Command Line (wget) to open a new dialog window with the command line prompt filled out.
      
      
      

      1. Run sudo yum install wget.
         
         
         
      2. Run the copied wget command from step b to have the script package downloaded to your machine.
         
         
         
         
         
         
3. With the package downloaded, run it on your system. From the folder where the above file was downloaded, run sudo tar -zxf XXXX where XXXX is the name of the file.
   
   
   
4. Run sudo ./ztna_packages.sh from the same folder.
   
   
   
5. This script will take you to the configuration setup screen, you can skip the next step below prompting you to run sudo ./setup_ztna. However, that command will be useful if you wish to adjust your configuration after the initial setup/config.
   If you wish to update the config later after going through the initial setup and config, then you should run the following:

   sudo su bitglass
   cd
   ./setup_ztna.sh