Installation overview
The process of installing Forcepoint NGFW consists of several high-level steps.
- Install and configure the SMC and a Management Client.
- Download licenses for the SMC components and the NGFW Engines, and install the licenses in the Management Client.
- If network address translation (NAT) is applied to communications between system components, define contact addresses for the SMC components in the Management Client.
- Define the Firewalls, IPS engines, and Layer 2 Firewalls in the Management Client. You can optionally define Master NGFW Engines and Virtual NGFW Engines.
- Configure interfaces and routing for the NGFW Engines in the Management Client.
- In the Management Client, generate the initial configuration for Firewalls, IPS engines, Layer 2 Firewalls, and Master NGFW Engines. You do not need an initial configuration for Virtual NGFW Engines.
- If you are not using a Forcepoint appliance that has pre-installed Forcepoint NGFW software, install the NGFW software on virtualization platforms or third-party hardware.
- Configure the NGFW software and apply the initial configuration to the NGFW Engines.
- Create and install a policy on the NGFW Engines.