Install a Log Server on the command line
Configure the Log Server settings in a command line installation.
Steps
-
Specify the IP address for the server.
To use the default option, press Enter. You can also enter a different IP address, then press Enter.If IP address binding is used, the server’s license must be generated with this IP address as the binding.
-
Specify the IP address of the Management Server that controls this server.
To use the default option, press Enter. You can also enter a different IP address, then press Enter. If there are multiple Management Servers, enter the IP addresses as a comma-separated list.
-
Specify the port on which the Log Server receives data.
To use the default option, press Enter. You can also enter a different port, then press Enter.
-
To install the server as a service, enter Y. Otherwise, enter N.
When installed as a service, the server starts automatically.
-
Specify the directory for storing log files.
To use the default option, press Enter. You can also enter a different directory, then press Enter.