Procedure to create the range-based IP spoofing table

Steps

  1. Go to the Configure > Networking > ARM > General page.
  2. Under IP Spoofing, select Enabled. Basic IP spoofing must be enabled to enable range-based IP spoofing.
  3. Under Range Based IP Spoofing, select Enabled.
  4. In the Client IP Addresses field, enter a comma separated list of individual IP addresses and/or IP address ranges.
    • In a range, the first IP address is separated from last with a hyphen. For example: 10.100.100.0-10.100.100.254
    • CIDR notation is allowed. Do not use spaces.
    • The Client IP Address list supports a maximum of:
      • 64 IPv4 addresses
      • 32 IPv4 address ranges
  5. In the Specified IP Address field, enter a single IP address.
  6. Click Apply to add the entry to the table.
    Warning: If any of the formatting is invalid, all of the data in that row is cleared.
  7. To add a new row to the table, click Add Row.
  8. To put new entries into effect, click Apply and then restart Content Gateway.
  9. Configure your network to ensure web traffic will be redirected back to the proxy.
    Contact your network equipment vendor or Technical Support for any needed assistance.