Configure > Security > Access Control > NTLM

The NTLM configuration options appear on the Configure pane only if you have enabled NTLM in the Features table on the Configure > My Proxy > Basic > General tab.

For more information about configuring NTLM, see Legacy NTLM authentication.

NTLM
Domain Controller Hostnames

Specifies the hostnames of the domain controllers in a comma separated list. The format is:

host_name[:port][%netbios_name] or IP_address[:port][%netbios_name]

If you are using Active Directory 2008, you must include the netbios_name or use SMB port 445.

If you change this option, you must restart Content Gateway.

Load Balancing

Enables or disables load balancing. When enabled, Content Gateway balances the load when sending authentication requests to the domain controllers.

Note: When multiple domain controllers are specified, even if load balancing is disabled, when the load on the primary domain controller reaches the maximum number of connections allowed, new requests are sent to a secondary domain controller as a short-term failover provision, until such time that the primary domain controller can accept new connections.

If you change this option, you must restart Content Gateway.