Protector SMTP service: Traffic Filter tab

Use the Traffic Filter tab to configure protector SMTP monitoring:

Steps

  1. Under Transaction Size, select the Minimum transaction size to monitor, in bytes.
  2. Under Direction:
    • Select Inbound to monitor incoming email traffic.
    • Select Outbound to monitor outgoing email traffic.
      Important: If you are using HTTP in active bridge mode or monitoring mode, be sure to set the Direction mode as Outbound only.
    • Select Internal to monitor internal email traffic.
  3. Under Source’s Network, select Enable filter to enable the source’s network filter. This tells Forcepoint DLP to watch for messages sent from specific networks and not analyze those messages.

    Enter the network IP address and subnet mask that should not be analyzed, then click Add. Repeat this process for each network address to skip.

    Continue with Protector SMTP service: SMTP Filter tab.