How to Connect Cisco ASA/FTD to Forcepoint ONE Cloud over IPsec Tunnel

Home
Configurations on Forcepoint ONE SSE
This section details the configurations required to setup IPsec tunnel on Forcepoint ONE SSE.

Introduction
Forcepoint ONE SSE cloud SWG solution enables web traffic filtering when a SmartEdge agent cannot be deployed on the end user's machine, such as for Guest users or IoT devices or when the organization does not want to deploy an agent.
Configurations on Forcepoint ONE SSE
This section details the configurations required to setup IPsec tunnel on Forcepoint ONE SSE.
- Creating Sites
  A Site represents a corporate location from which traffic will originate. While creating a Site, you can configure either GRE or IPsec tunnel through which traffic should be sent over to cloud and create or add subnets groups within the site.
- Viewing Tunnels
  After creating tunnels, you can monitor the status of each tunnel under Analyze > Tunnels page.
Configurations on Cisco ASA/FTD device
This section details the configurations you need to carry on Cisco ASA/FTD version 9.8 or later version using the details from the Analyze > Tunnels page in Forcepoint ONE SSE.
Troubleshooting IPsec tunnels
The troubleshooting information describes some typical problems that you might encounter in configuring and establishing your IPsec tunnels, and the suggested actions for how to resolve the problems.

Configurations on Forcepoint ONE SSE

This section details the configurations required to setup IPsec tunnel on Forcepoint ONE SSE.

Creating Sites
A Site represents a corporate location from which traffic will originate. While creating a Site, you can configure either GRE or IPsec tunnel through which traffic should be sent over to cloud and create or add subnets groups within the site.
Viewing Tunnels
After creating tunnels, you can monitor the status of each tunnel under Analyze > Tunnels page.

Copyright © 2024 Forcepoint LLC