Add IP addresses to Layer 2 Firewall Cluster interfaces

Add IP addresses to Layer 2 Firewall Cluster interfaces.

1. In the navigation pane on the left, select Interfaces.
2. Right-click a physical interface or a VLAN interface and add the IP address in one of the following ways:
   • To add an IPv4 address, select New > IPv4 Address
   • To add an IPv6 address, select New > IPv6 Address
3. Click the IPv4 Address or IPv6 Address cell in the table and enter the IP address for each node.
   Tip: To resolve the IP address from a DNS name, right-click the field, then select Resolve From DNS Name.
4. (IPv4 addresses only) If necessary, double-click the Contact Address cell in the table and define the contact address for each node.
   • In the Default field at the top of the dialog box, enter the default contact address. The default contact address is used by default whenever a component that belongs to another Location connects to this interface.
   • If components from some Locations cannot use the default contact address, click Add to define Location-specific contact addresses.
5. (IPv4 addresses only) Check the automatically filled-in Netmask and adjust it as necessary.
6. (IPv6 addresses only) Check the automatically filled-in Prefix Length and adjust it as necessary.
7. Click OK.
8. Click Save.
   Do not close the Engine Editor.