How to Connect Juniper SRX to Forcepoint ONE Cloud over GRE Tunnel

Home
Configurations in Forcepoint ONE SSE
This section details the configurations required to setup GRE tunnel in Forcepoint ONE SSE.

Introduction
Forcepoint ONE SSE Cloud SWG solution enables web traffic filtering when a SmartEdge agent cannot be deployed on the end user's machine, such as for Guest users or IoT devices or when the organization does not want to deploy an agent.
Configurations in Forcepoint ONE SSE
This section details the configurations required to setup GRE tunnel in Forcepoint ONE SSE.
- Creating Sites
  A Site represents a corporate location from which traffic will originate. While creating a Site, you need to configure GRE tunnel through which traffic should be sent over to cloud and create or add subnets groups within the site.
- Viewing Tunnels
  After creating tunnels, you can monitor the status of each tunnel under Analyze > Tunnels page.
Configurations on edge device
This section details the configurations you need to carry on Juniper SRX device using the details from the Analyze > Tunnels page in Forcepoint ONE SSE.
Troubleshooting
The following table lists some problems that may be encountered in configuring and establishing your tunnel, with some suggested actions.

Configurations in Forcepoint ONE SSE

This section details the configurations required to setup GRE tunnel in Forcepoint ONE SSE.

Creating Sites
A Site represents a corporate location from which traffic will originate. While creating a Site, you need to configure GRE tunnel through which traffic should be sent over to cloud and create or add subnets groups within the site.
Viewing Tunnels
After creating tunnels, you can monitor the status of each tunnel under Analyze > Tunnels page.

Copyright © 2024 Forcepoint LLC