Configuring Forcepoint DLP system modules

Although configuration settings may be customized at any time, the default module configuration may be sufficient:

  • Typically, in Forcepoint Web Security deployments, no additional configuration is needed.
  • In full Forcepoint DLP deployments, in most cases, the only module that must be configured after installation is the protector. This is covered in Configuring the protector.

To configure a Forcepoint DLP system module:

Steps

  1. Go to the Settings > Deployment > System Modules page in the Data Security module of the Forcepoint Security Manager.
  2. Click a module.
  3. Complete the fields as shown in the appropriate section below. Note that not all modules are available for all deployments.
    • Configuring the Forcepoint DLP management server
    • Configuring a supplemental Forcepoint DLP server
    • Configuring the fingerprint repository
    • Configuring the endpoint server
    • Configuring the crawler
    • Configuring the forensics repository
    • Configuring the policy engine
    • Configuring the OCR server
    • Configuring the protector
    • Configuring ICAP
    • Configuring the Web Content Gateway module
    • Configuring the Forcepoint Email Security module
    • Configuring Forcepoint DLP Email Gateway
    • Configuring the integration agent
    • Configuring protector services
    • Configuring the analytics engine