Protector HTTP service: Traffic Filter tab

Use the Traffic Filter tab to configure protector HTTP monitoring.

If you are using HTTP and SMTP in active bridge mode or monitoring mode, be sure to set the Direction mode to outgoing only!

Steps

  1. Under Transaction Size, select the Minimum transaction size to monitor, in bytes.
  2. Under Direction:
  3. Under Source’s Network, select Enable filter to enable the source’s network filter. This tells the system to watch for transactions sent from specific networks and not analyze those transactions.
    • Select Inbound to monitor incoming HTTP traffic.
    • Select Outbound to monitor outgoing HTTP traffic.
    • Select Internal to monitor internal HTTP traffic.

    Enter the network IP address and subnet mask to not analyze then click Add. Repeat this process for each network address you want to skip.

    Continue with Protector HTTP service: HTTP Filter tab.